Elecraft P3 High-Performance Panadapter Manual User Manual
Page 54
54
Locate the RF Board, the four 7/16” (14.3 mm) inside tooth lock washers and the two 7/16” (14.3 mm)
nuts.
Mount the board on the rear panel as shown in Figure 17. Be sure two lock washers are between the BNC
connectors and the inside surface of the rear panel and two lock washers are between the nuts and the rear panel
as shown. Tighten the nuts gently until they slightly compress the lock washers. That will hold the
assembly securely in place.
Over-tightening may place unnecessary strain on the RF board.
Figure 17. RF Board Installation.
NOTES:
1. The RF board connectors may be labeled RF OUT and RF IN while the rear panel is
labeled IF OUT and IF IN. That is normal.
2. The SENSOR connector opening in the rear panel is for future use.