ETS-Lindgren HI-2790B Calibration Comparison System - Manual (Page 40)

40 Specifications www.ets-lindgren.com
Repeatability of Measurements: If the recommended procedures are
followed, an operator can repeat
measurements to plus or minus 2%
(of this, plus or minus 1% will be
due to the last digit uncertainty of
the digital meter on the
HI-1710 LCR).
Inside Dimensions of Anechoic
Material:
18 in x 18 in x 18 in
Environmental:  Operating temperature:
10 degrees to 40 degrees C
 Humidity: 5% to 95% relative
humidity, non-condensing
Power Cable: This unit is shipped with a three-wire
power cable that meets or exceeds
the requirements of EN60799.
When this cable is connected to an
appropriate AC power source, it
connects the chassis to earth
ground. The type of power cable
shipped with each unit depends on
the country of destination.
Note: The power cable used must be rated for a minimum of
250V/10A.