ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 18)

Optional Shaft Kit Installation Instructions MODEL 2065 LOPRO TURNTABLE
14 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
SHAFT HOUSING INSTALLATION
Next assemble one of the two PVC outer shaft housings into one of
the two end floor supports. The floor supports are split into a top
and bottom half that clamp together. Loosen the top ½-13 hex nuts
to separate these two split pieces. Insert one white bushing
followed by the end of one housing into the floor support. Then
tighten the two top nuts to clamp the floors support around the
housing and bushing.
Install the housing assembly onto the base plate of the turntable
mechanical assembly using two ½-13 x 1.5 inch hex bolts that will
be inserted through the tie plate. Be sure the housing is square with
the turntable base to insure proper shaft alignment.
If DIM1 is 3035mm (9ft 11.5 inches) or less then the mid floor
support is not needed go on to the “Drive Shaft Installation”
section.
If DIM1 is more than 3035mm (9ft 11.5 inches) then the mid floor
support is required.
If required, assemble the middle floor support with a white bushing
onto the end of the shaft housing. Be sure the housing is square
with the turntable base to insure proper drive-shaft alignment after
final assembly.
DRIVE SHAFT INSTALLATION
The drive shaft has two “reduced ends”. Be sure the 2.69 cm (1.06
in) diameter end with the groove goes toward the turntable. The
knurled 2.54 cm (1.0 in) diameter end will point toward the motor
drive.
NOTE: The coupling on the drive shaft will not fit through the
white bushing if a middle support is used. The coupling should be
on the motor drive side of the middle support when the drive shaft
is installed into the housing.
Archived 3/18/10