Gastroback 41406 Design Mincer Electronic Pro - Manual (Page 16)

38
or cookie attachment) off the worm housing.
TIP: If the tools are stucked knock the mincer carefully on a stable cutting board.
The grinding disc should be facing up.
ATTENTION: Be careful not to damage your bench top, the cutting board or the mincer.
6. Remove meat residues.
Operate as described:
ATTENTION: Never put the appliance or parts of the appliance in the
dishwasher or use abrasives for cleaning! This will cause discoloura-
tion and corrosion.
7. Wash all parts thoroughly in hot soapy water. Do not use aggressive detergents.
The parts are not suitable for dishwasher. Soak parts with desiccated food leftovers
a few minutes in warm soapy water and use a nylon cleaning brush or cleaning
sponge for cleaning. Rinse all parts with running water and dry them accurately.
8. Grease the grinding disc and knife with salad oil to prevent air corrosion.
WARNING: Ensure that the switch and cable do not come into contact with
water! Should this inadvertently happen, all parts must be completely dry before the
appliance is used again. Never let water or other liquids run into the motorblock.
Never clean the line cord or the appliance in the dishwasher, pour liquids over
the appliance or douse or dip it in water or other liquids. In case that water or other
liquids ran into the appliance while operating turn off the appliance immediately, pull
the plug and dry the appliance with a clean cloth.
9. The motor block must only be wiped clean with a moist cloth. Do not clean the
motor block under flowing water, nor should it be immersed in water! Do not use
alcohol, benzine, etc.!