Gastroback 41406 Design Mincer Electronic Pro - Manual (Page 17)

39
Trouble shooting guide
Always clear blockage according to the following instructions. For the case that
you are unsuccessful take the appliance to an authorised specialist reparation shop.
Possible problem Easy solution
The mince is not fine enough. Use a smaller grinding disc and/or mince the ingredients more then once.
There are still ingredients in the feed chute The mincer is blocked. Turn the appliance off immediately and operate
but no mince is coming out of the mincer. according to the instructions ´Clear a blocking`.
The motor stops running while operating. The overload protection might got activated. Turn the appliance off
immediately and operate according to the instructions ´Clear a blocking`.
After cleaning the motor does not get started • Is the power cord plugged in?
again when turning the appliance ON.
• The motor might be blocked with some hard substance (for example
a bone). Turn the appliance off immediately and pull the plug.
• Disassemble and clean the appliance. Operate according to the
instructions ´Care and cleaning`.
• If the problem is not solved after the cleaning, take the appliance
for technical maintenance and repair to an authorised specialised
reparation shop.
The mincer blocks up permanently • To ensure that the mincer does not seize, never operate it under
while operating. excessive pressure. Operate in a slow and constant pace. Do not
try to rush the procedure by pushing down the meat with force.
• For mincing hard ingredients really fine start with the grinding disc
with the bigger holes. Mincing the second time use the finer grinding
disc.
The worm housing moves while operating The closing ring loosened. Turn the appliance off immediately. Assemble
the worm housing according to the instructions ´Assemble for mincing`.
The mince leaks out at the side of the The closing ring is not screwed on tight enough. Turn the appliance off
closing ring. immediately and then pull the plug. Tighten the closing ring but do not
overwind the winding. If the problem still occurs disassemble and clean the
appliance.