Hollywood Racks HR1000 SportRider 2 bike - Manual (Page 3)

Step 7A: Install frame hooks:
For ratchet style hooks only:
Slide long frame hook down
vertical post facing vehicle.
Then slide short frame hook
onto post, facing away from
vehicle. You should hear be able
to hear the spring loaded lever
engaging the teeth on the post
as shown in fig. 8.
Step 6: Installing into a 1 ¼” trailer
Fig. 9
Note: The receiver tube comes
ready for installation into a 2”
hitch. If you have a 1 ¼” hitch,
use the provided hex wrench to
remove the plastic spacer as
shown in Fig. 9.
Place lock washer and flat washer
onto hitch pin bolt as indicated.
Insert the receiver tube into the
hitch. Align the holes, insert the
hitch pin bolt and tighten securely
using a ¾” wrench.
Fig. 10 Fig. 11
3
Fig. 8
7B: For Precision Slide style clamps only
Installation and operation of
“Precision-Slide” Clamp System
Install the clamps on the vertical post:
Position the long frame hook on top of the round vertical post facing the vehicle. Squeeze the lever and the tab together, so
that the lever is all the way up (engaged). Now wiggle the plastic housing down onto the tube aligning the index guides with
the index slots. You may have to gently tap it with your other hand. Remember the lever must be engaged to install it
onto the tube. Repeat for the short hook facing in the opposite direction.
Using the clamps:
After the clamp is installed, it can only be raised by engaging the lever. The clamp can physically be pushed down
without engaging the lever but it is highly recommended that the lever also be engaged when lowering the clamp.
Squeeze lever all the way, lever
must be completely engaged.