Chamberlain RIFMS2 - Manual

Carton Inventory
Overview
Assemble Intercom
Model RIFMS2
Wireless Flush Mount Intercom
Mounting Frame (2)
1
Intercom (2)
Fastener (8)
Screw (8)
®
Channel Button: Press the Channel button to set
intercom to one of four secure channels or the paging
channel. The default channel for the intercom is the
paging channel where all four channel lights are lit.
An intercom on a channel can only hear an intercom
on the same channel or on the paging channel.
Conference Mode: Conference
Mode allows multiple intercoms to
participate in a conversation
compared to Normal Mode in which
only two intercoms can communicate.
All intercoms must be set to the same channel or the
paging channel to be in Conference Mode. To place
intercoms in Conference Mode set Dipswitch #1 on
block 2 to the UP position.
Battery: When batteries are low intercom will emit
two beeps every ten minutes. Replace with
C batteries (not provided).
NOTE: To prevent damage to the circuit DO NOT use
C size Lithium batteries.
Operation & Features
Talk Button
Talk Button: To talk, hold
down the Talk button. All
intercoms in the network that
are on the same channel will
receive the signal. Release the Talk button when
done talking and within 10-15 seconds press and hold
the Talk button of a different intercom to make a
secure channel between the two. Once the channel is
made the other intercoms in the network cannot hear
the conversation.
Volume: Hold down the Talk button and press the
Channel button repeatedly to cycle through the
volume levels.
The Intercom has up to a 1000' range and allows
multiple simultaneous conversations, using a
900 Mhz secure digital radio link. The intercoms form
an exclusive network and respond only to other
intercoms in the network.
Channel Button
Dipswitch Blocks
Block 1 Block 2
Install 4 C batteries (not
provided). Secure
batteries with fastening
strip. LEDs will light.
NOTES:
• Ensure that the batteries
are securely fastened or
they may fall out during
installation.
• To prevent damage to the circuit DO NOT use
C size Lithium batteries.
Channel Lights