Chamberlain RIFMS2 - Manual (Page 2)

2
Programming Intercom
Create New Network
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Press and hold both buttons on the intercom for
5 seconds. An initial beep will be heard followed by a
second beep. The channel lights will flash. Within 10
seconds put the second intercom into Learn Mode
(refer to table below).
Add to an Existing Network
Press and hold both buttons on the new intercom for
5 seconds. An initial beep will be heard followed by a
second beep. The channel lights will flash. Within 10
seconds put any networked intercom into Learn Mode
(refer to table below).
INTERCOM LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
INTERCOM LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.