Inserting film, 35 mm negative and positive film (sleeve type) – Canon FS 2720 U User Manual
Page 14
14
CanoScan FS2720U Film Scanner
Inserting Film
35 mm Negative and Positive Film (Sleeve Type)
Load 35 mm negative films and positive films that haven’t been slide mounted
into the film holder for insertion into the film scanner.
1.
Have the film and film holder at hand.
2.
Slide the guide on the film holder to the ‘R’ position.
•
Slide the guide all the way until it rests against the stopper.
3.
Open the film holder.
•
Gently twist the tab at the end of the film holder and open one half as shown.
4.
Load the film into the holder.
•
Place the film face up in the groove so that the image is viewed correctly when
the ‘R’ on the film holder is facing up.
•
The orientation of an image can be corrected with the rotate command of
the scanning software, CanoCraft FSU or Plug-in Module FSU, if the film is
incorrectly loaded.
•
Read the section entitled Final Film Format
for information regard-
ing film mounts and sleeves.