Craftsman 247.88855 - Manual (Page 23)

23
• Reassemble the new friction wheel rubber to
the friction wheel assembly tightening the six
screws in rotation and with equal force.
• Position the friction wheel assembly up onto
the pin of the shift rod assembly and slide the
shaft through the friction wheel. See Figure 30.
• Slide the shaft into the hex I.D. of the sprocket,
the spacer and the left ball bearing and secure
with the bell washer and hex bolt.
Figure 30
Shift Rod
Assembly
Shaft
Pin
Friction
Wheel
Support
Bracket
Sprocket
Spacer
Bolt
Washer
Bearing
Carburetor
WARNING: If any adjustments are made to
the engine while the engine is running (e.g.
carburetor), keep clear of all moving parts.
Be careful of heated surfaces and muffler.
If you think the carburetor needs to be adjusted, see
your nearest authorized Tecumseh Service Outlet.
Carburetor
WARNING: If any adjustments are made to
the engine while the engine is running (e.g.
carburetor), keep clear of all moving parts.
Be careful of heated surfaces and muffler.
If you think the carburetor needs to be adjusted, see
your nearest authorized Tecumseh Service Outlet.