Hybrid Racing WaveTrac LSD - Manual (Page 6)

6
Install Guide
STEP 10:
Unbolt and remove the reverse shift
fork using a 10mm socket.
Reassem-
bly Tips:These should be torqued to 11
lb-ft (15 N-m).
STEP 11:
Remove the oil gutter plate.
STEP 12:
Wrap the input shaft's splines with
masking tape. This is done to avoid
damaging the input shaft seal as the
gearset is removed.
Reassembly Tips:
Don't remove the tape from the
mainshaft spline until after the gearset
has been reinstalled. This will help to
protect the oil seal during reassembly.
Next, hold the gearset and shift forks
as shown in figure 12 and gently lift the
gearset and shift forks out of the tran-
mission case.