Enable/disable parksense, Service parksense, Cleaning parksense – Jeep 2010 Grand Cherokee - Owner Manual User Manual
Page 123
NOTE:
The Rear Park Assist system will MUTE the
radio, if on, when the system is sounding an audio tone.
Enable/Disable ParkSense
ா
ParkSense
can be enabled and disabled with a switch
located on the upper switch bank of the instrument
panel.
Press the switch once to turn ParkSense
on,
push the switch a second time to turn Park-
Sense
off.
When the switch is pressed to disable the system, the
instrument cluster will display the “PARK ASSIST DIS-
ABLED” message. Refer to “Electronic Vehicle Informa-
tion Center (EVIC)” in “Understanding Your Instrument
Panel” for further information. When the shift lever is
changed to REVERSE and the system is disabled, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the message.
The ParkSense
switch LED will be ON when the system
is disabled or defective. The ParkSense
switch LED will
be OFF when the system is enabled.
Service ParkSense
ா
When ParkSense
is defective, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display the “SERVICE PARK ASSIST SYSTEM” message.
Refer to “Electronic Vehicle Information Center (EVIC)”
in “Understanding Your Instrument Panel” for further
information. If “SERVICE PARK ASSIST SYSTEM” ap-
pears in the EVIC after making sure the rear fascia/
bumper is clean and free of snow, ice, mud, or other
debris, see your authorized dealer.
Cleaning ParkSense
ா
Clean the ParkSense
sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
age the sensors.
122
UNDERSTANDING THE FEATURES OF YOUR VEHICLE