Clarion SIRIUS DSC920S - Manual (Page 5)

DSC920S
5
English 4.OPERATIONS
Turning the power on/off
1. Press the [SAT] button to turn the power on/
off.
When the power is turned on, “SAT” is dis-
played in the Operation status indication and
then the display is changed to the channel
being received.
Verifying your Sirius ID
1. Press and hold the [SS] button for 1 second
or longer to enter the Adjust mode.
2. Press the [ a ] or [ d ] to select the “ESN
>>”.
∗
When the unit enters the SIRIUS ID display
mode, “ESN>>” is displayed and then the dis-
play is changed to the high-order 6 digits of
the SIRIUS ID (“012345
z z z z z ”) in the Operation
status indication.
3. Press the [ z ] button to change the low-or-
der 6 digits of the SIRIUS ID (“678901 w ”).
∗
To display the high-order 6 digits of the
SIRIUS ID again, press the [
w ] button.
4. Press the [ a ] or [ d ] button to return the
previous mode.
Selecting a band
1. Press the [BAND] button to select a band.
BAND indication (“SAT1”, “SAT2” or “SAT3”)
is light in the display.
Tuning mode
There are two channel selection modes: seek
mode and manual mode.
● Manual tuning
Any channel including channels without broad-
casts and channels not covered by the contract
can be selected during manual tuning.
1. Press and hold the [BAND] (BND) button for
1 second or longer.
∗
This changes the seek mode to manual mode
and the “MANU” indicator on the display lights.
When this operation is performed in manual
mode, the seek mode is engaged and the
“MANU” indicator on the display goes off.
Notes:
• The receiver automatically reverts to the seek
mode when the [ a ] or [ d ] button is not used for
7 seconds in the manual mode.
2. Press the [ a ] or [ d ] button. The receiver
moves to channels above or below the cur-
rent channel one by one.
3. Press and hold the [ a ] or [ d ] for 1 second
or longer.
The receiver moves to seek channels below
or above the current channel and the chan-
nel found when either button is released is
received.
● Seek tuning
Only channels that can be received are selected
while channels without broadcasts and channels
not covered by the contract are automatically
skipped.
1. Press the [ a ] or [ d ] button.
The receiver seeks the next available chan-
nel below or above the current channel.
2. Press and hold the [ a ] or [ d ] button.
The receiver moves to seek channels below
or above the current channel. If the channel
found when either button is released is avail-
able that channel is received. Otherwise,
seeking continues until an available channel
is found.
Preset memory
3 bands are available for preset memory and 6
channels for each band, a total of 18 channels
can be stored in memory.
The indication concerning the preset memory is
displayed both in the BAND indication for the
band being received (“SAT1”, “SAT2”, or
“SAT3”) and in the Preset channel indication for
the preset number.
● Recalling a preset station
1. Press the [ w ] or [ z ] button to recall a pre-
set station. Each time the button is pressed,
preset stations are recalled in a sequential
order.
∗
When the [P-M] button is pressed and the Pre-
set memory mode is engaged, preset stations
cannot be recalled.
∗
When the button is pressed, the sound is
muted and reception channel data are dis-
played in the Operation status indication in the
following order.
Channel number (for example “CH 051”) ➜
abbreviated 8-digit channel name ➜ returned
to the original display mode