Rear wiper blade removal/installation – Jeep 2013 Grand Cherokee SRT - Owner Manual User Manual

Page 557

Advertising
background image

Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.

Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.

NOTE:

Life expectancy of wiper blades varies depending

on geographical area and frequency of use. Poor perfor-
mance of blades may be present with chattering, marks,
water lines or wet spots. If any of these conditions are
present, clean the wiper blades or replace as necessary.

Rear Wiper Blade Removal/Installation

1. Lift the pivot cap on the rear wiper arm upward, this

will allow the rear wiper blade to be raised off of the
liftgate glass.

NOTE:

The rear wiper arm cannot be raised fully up-

ward unless the pivot cap is raised first.

2. Lift the rear wiper arm upward to raise the wiper

blade off of the liftgate glass.

1 — Wiper Arm
2 — Pivot Cap

7

MAINTAINING YOUR VEHICLE

555

Advertising
This manual is related to the following products: