ClearOne comm FlexCam - Manual (Page 5)

FlexCam iCam Digital — Getting Started 7
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Sofware drivers for Windows
Before you can use your FlexCam iCam Digital with a computer, you must install the proper
USB drivers on your PC. The drivers are found on the USB Software and Driver Disk that
came with your camera. Depending on the Windows version you are using, the installation
process may vary slightly. The new hardware screens on your computer may not look exactly
like the ones pictured in this section. If the Found New Hardware Wizard does not
automatically locate the drivers, you may need to manually direct your browser to the
NUVSION.sys file on the ArcSoft CD. After the drivers are properly installed you will need to
install the ArcSoft Software Suite that includes VideoImpressions and PhotoStudio. For
information on installing the ArcSoft Software Suite, please refer to page 11.
To install the drivers on Windows
1. Insert the USB Software and Driver Disk into the CD-ROM drive.
2. Plug in the FlexCam iCam Digital. The Found New Hardware Wizard will open.
3. Click Next .
Figure 6. Found new hardware
FlexCam iCam Digital — Getting Started 6
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Connections
You can connect the FlexCam iCam Digital to a TV, a VCR or an LCD projector using the
included 12' S-video cable. If your video display device requires a composite signal, use the
provided S-video to composite adapter.
To connect to a TV, VCR or projector
1. Connect the S-video cable of the FlexCam iCam Digital to the video input on the display
device.
Note: If needed, use the S-video to composite video adapter.
2. Attach the power plug to the power jack on the back of the camera and plug the power
adapter into the wall.
To connect the camera to a computer
1. Connect the USB cable of the FlexCam iCam Digital to the USB input on the back of the
computer.
2. Attach the power plug to the power jack on the back of the camera and plug the power
adpater into the wall.
Getting Started
S-VIDEO USB POWER
DC 12V
FlexCam iCam Digital
To S-video
Input To S-video
Input
Composite Adapter
To Composite
Figure 4. Connection to an S-video display device
S-VIDEO USB
POWER
DC 12V
FlexCam iCam Digital
PC or Mac
To USB
Connector To USB
Output
To Power
To Outlet
Figure 5. Connection to computer