ClearOne comm FlexCam - Manual (Page 7)

FlexCam iCam Digital — Getting Started 11
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
FlexCam iCam Digital — Getting Started 10
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Sofware drivers for Macintosh
Before you can connect your FlexCam iCam Digital to a Macintosh, you must install the
USB drivers. The drivers are found on the USB Software and Driver Disk that came with
your camera. The FlexCam iCam Digital is compatible with Mac OS 8.6 – 9.2.
To install USB drivers on a Mac
1. Insert the USB Software and Driver Disk into the CD-ROM drive.
2. Double-click the USB Software and Driver Disk icon to open the CD content window.
3. Double-click the FlexCam iCam Digital folder icon.
4. Double-click the correct operating system folder.
5. Click iCam Digital to install drivers. Once drivers are installed, restart the computer.
6. Plug the USB cable into a USB port on the Mac.
Figure 11. ArcSoft on Mac
Installing ArcSoft Software
To install ArcSoft Software on Windows
1. From My Computer, right-click the ArcSoft CD icon and select Explore .
2. Double-click Setup.exe .
3. Follow the on-screen prompts. Both programs are installed through the same installation
wizard.
4. Restart your computer.
To install ArcSoft Software on a Mac OS
1. Double-click the Video Impression 1.6 Installer icon (see Figure 11) and follow the
on-screen prompts.
2. When Video Impression finishes installing, double-click the PhotoStudio Installer and
follow the on-screen prompts.
3. Restart your computer.
Figure 13. Installing the ArcSoft programs
Figure 12. iCam Digital driver installer