Kendon Single Ride-Up SRL Stand-Up User Manual
Page 8
714-630-7144
www.KendonUSA.com
- 6 -
Usage Instructions for Kendon Ride-Up Single SRL Trailer
Thoroughly read and understand these instructions and the attached Owner’s
Manual for Kendon Stand-Up™ Trailers.
Attach the Trailer to Tow Vehicle making sure the coupler completely
engages the ball and that the coupler latch is locked down. Refer to the
diagram below for an illustration of the coupler latch in the closed position.
Coupler Latch in Properly Closed Position
Proper Ramp Attachment for Loading & Unloading
Remove the three (3) ramps from the trailer (be careful to not lose the mounting
hardware). The Two (2) outer ramps are stored on top of the bed of the trailer
and the one (1) center loading ramp is stored underneath the rear folding
section of the trailer.
There are three (3) different ramp sections; Left Side Ramp, Center Loading
Ramp and Right Side Ramp. Please refer to the following diagram for an
illustration of the ramps.
Ramps are clearly marked, Right, Center and Left. They cannot be
interchanged. The following illustration shows the correct ramp configuration.
Right and Left Ramps are not constructed to hold the weight of the
motorcycle and should never be used as a loading ramp for any vehicle.
Right and Left ramps are for the riders footing during the loading and
unloading process.