Koala Kare KB110-SSRE - Manual (Page 3)

Step 1.
Remove changing station from the shipping container and check for any freight damage.
Identify the best location for installing the unit. Hold the unit in place and open the bed.
Make sure you have taken the operating clearance into consideration.
Step 2.
Select the wall area where the unit will be
installed. Measure from the floor 46½” (1181
mm) on stud center and mark the wall. Hold the
unit in place to verify the alignment. Mark rough
opening 35½” W x 20½” H (902 mm x 521
mm) and cut a hole in the wall with a minimum
depth of 4¼” (108 mm) as measured from the
finished surface of the wall (ie: tile, drywall, etc).
Construct mounting frame as indicated in the
illustration. If the wall surface is masonry or
tile over wood studs, use caution when cutting
rough opening.
Step 3.
The unit will be mounted using four ¼” x 3”
wood screws through side holes as shown in
illustration.
Step 4.
Place the unit into the recessed area and use
the side mounting holes as a guide to drill a
pilot hole using a
⅛” drill bit. Insert the screws
and flat washers through the side mounting
holes to hold the unit in place. It may be necessary to adjust the level of unit by using a
shim on the top right or left side of the unit before tightening securely to the studs.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built in
dispenser with sanitary bed liners. Replacement parts and additional liners can be
purchased from your local distributor or by calling toll free 888.733.3456 or 303.539.8300
in the U.S.
Horizontal Baby Changing Station Recessed Mounted
Model Numbers KB100-ST and KB110-SSRE
INSTALLATION INSTRUCTIONS