Koala Kare KB112-01RE - Manual (Page 2)

Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the Koala Baby
Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.
Koala Baby Changing Stations are intended for use on an existing countertop surface that is capable
of holding significant weight. Unit should be permanently mounted to the countertop surface per the
installation instructions. When an infant is placed onto changing surface, use strap and buckle to secure
infant to changing surface. Never Leave Child Unattended.
Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted
to make strap tighter or looser as required.
You are responsible for the safe operation and use of this unit. Not intended to hold more
than 50 lbs.
Inspection Criteria:
A properly maintained baby changing station:
• Is free of any cracks or damage that can cause injury.
• Has two sides of a retaining strap free from damage.
• Check straps for wear. Buckle should lock with an audible click.
• Check labels and replace as needed.
TOOLS NEEDED
Gloves Phillips Head
Screwdriver Level Pencil
Drill 1/8” Drill Bit
(regular and
masonry) Measuring
Tape Saw
KB112-01RE COUNTERTOP BABY CHANGING STATION
INSTALLATION INSTRUCTIONS
HARDWARE PROVIDED
8 Screws 8 Screw Covers 8 Screw Cover Bases