Koala Kare KB112-01RE - Manual (Page 3)

Countertop Mounted Baby Changing Station
Model Number KB112-01RE
INSTALLATION INSTRUCTIONS
Step 1.
Remove changing station from the shipping
container and check for any freight damage.
Identify the best location for installing the unit.
Step 2.
Remove the rough opening template from
the shipping carton. Remove paper template
and lay it on the surface where the unit will be
mounted. Drill hole in interior of rough opening
to allow saw access. Cut out rough opening.
Step 3.
Construct under counter support as shown in
the illustration. Support should be 3” below
bottom of mounting surface.
Step 4.
Place the Countertop Baby Changing Station (BCS) onto counter surface and
place in desired position. Using the mounting holes as a guide, mark the screw
hole locations with a pencil. Remove BCS and drill holes with a 1/8” diameter drill
bit.
Step 5.
Place BCS onto counter surface using the drilled holes as a guide. Slide screw
through the screw cover base. Screw fasteners through holes into countertop
surface. Securely snap screw cover onto screw cover base. Apply a suitable
water sealant (not provided) such as silicone around the base of the BCS.