Koala Kare 877-KIT - Manual

Materials Supplied: Tools Needed:
Shock Flat Head Screwdriver
1. Remove the Baby Changing Station from the wall.
2. Turn the unit over so that you can access the shock on
the back side of the station. On both ends of the shock
there is a “C” clip that holds the shock onto the ball stud.
To remove the shock, carefully slide a flat head screwdriver
in-between the shock and the “C” clip. Once the tension on
the “C” clip is removed you will be able to pull the shock off
the ball stud. Repeat on both ends of the shock. Remove
the shock completely from the unit.
3. Open the door of the Baby Changing Station all of the
way. You will be able to locate the lower ball stud on the
bottom of the door. Slide the thin end of the replacement
shock down through the hole in the back of the unit.
4. Snap the replacement shock onto the lower ball stud.
Make sure the shock is secured to the ball stud by slightly
twisting the shock to make sure that it does not come
unhooked.
5. Close the door of the Baby Changing Station all of the
way. With the door completely closed compress the shock
by pressing downward so that it can be attached to the
upper ball stud. Snap the shock onto the ball stud. Twist
the shock to make sure that it does not come unattached
from the ball stud.
6. Open and close door of unit several times to make
sure that the shock is functioning properly. Remount unit
following the proper installation instructions that were
provided with the unit. Once the unit is properly installed,
check the shock several times by opening and closing the
Baby Changing Station.
®
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
KB100 / KB101 REPLACEMENT SHOCK INSTRUCTIONS
P/N 874-KIT (KB100)
P/N 877-KIT (KB101)
P/N 306 December 2010