Kontron CP6925 - Manual (Page 40)

Page 3 - 4 Doc.ID: 35008, Rev 1.0
Installation CP6925
CUSTOMER SPECIFIC
P R E L I M A R Y
3.2 CP6925 Installation Procedures
The following procedures are applicable the installation of the CP6925 in a system. Procedures
for standard removal are found in its respective chapter.
To perform an installation of the CP6925 in a system proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that the board is properly configured for operation in accordance with application
requirements before installing.
3. To install the CP6925 perform the following:
1. Ensure that no power is applied to the system before proceeding.
2. Carefully insert the board into the slot designated by the application requirements for
the board until it makes contact with the backplane connectors.
3. Using the ejector handles, engage the board with the backplane. When the ejector
handles are locked, the board is engaged.
4. Fasten the front panel retaining screws.
5. Connect all external interfacing cables to the board as required.
6. Ensure that the board and all required interfacing cables are properly secured.
The CP6925 is now ready for operation. For operation of the CP6925, refer to appropriate
CP6925 specific software, application, and system documentation.
Warning!
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP6925 nor other system boards are physically damaged by
the application of these procedures.
Warning!
When performing the next step, DO NOT push the board into the back-
plane connectors. Use the ejector handles to seat the board into the back-
plane connectors.