Kontron CP6925 - Manual (Page 41)

Doc.ID: 35008, Rev 1.0 Page 3 - 5
CP6925 Installation
CUSTOMER SPECIFIC
P R E L I M A R Y
3.3 Standard Removal Procedures
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that no power is applied to the system before proceeding.
3. Disconnect any interfacing cables that may be connected to the board.
4. Unscrew the front panel retaining screws.
5. Disengage the board from the backplane by first unlocking the board ejection handles
and then by pressing the handles as required until the board is disengaged.
6. After disengaging the board from the backplane, pull the board out of the slot.
7. Dispose of the board as required.
3.4 Software Installation
There is no software installation required for this board.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP6925 nor system boards are physically damaged by the
application of these procedures.