Kontron CP6005X-SA - Manual (Page 20)

D R A F T — F O R I N
T E R N A L U S E O N L Y
20 www.kontron.com
User Guide
CP6005(X)-SA
Sock
et
s
Onboard Connectors
» One XMC connector, J19 (P15)
» Two SATA connectors
» One 7-pin, standard SATA connector, J14
» One 34-pin, SATA extension connector, J16
» One JTAG connector, J15
» One XDP-SFF (debug) connector, J25
» Four CompactPCI connectors J1, J2, J3 and J5
» Two ZDplus high-speed serial rear I/O connectors, J4 and J41 (PICMG 2.20)
(CP6005X-SA)
» Two 204-pin DDR3L SODIMM sockets, J17 and J18
LEDs
Front Panel LEDs IPMI LEDs:
» I0/I1 (red/green): Software status of the IPMI controller
System Status LEDs:
» WD (green): Watchdog status
» TH (red/green): Temperature status
» HS (blue): Hot swap status
General Purpose LEDs:
» LED3–0 (red/green/amber): General purpose / POST code
Ethernet LEDs:
» ACT (green): Network link / activity
» SPEED (green/orange): Network speed
Switches
DIP Switches Two onboard DIP switches, SW1 and SW2 for board configuration on the rear side
of the board
Reset Switch One hardware reset switch on the front panel
Hot Swap Switch One switch for hot swap purposes integrated in the front panel in accordance
with PICMG 2.1 Rev. 2.0
Ti
m
er
Real-Time Clock Real-time clock with 256 Byte CMOS RAM; battery-backup available
Watchdog Timer Software-configurable, two-stage Watchdog with programmable timeout ranging
from 125 ms to 4096 s in 16 steps
Serves for generating IRQ or hardware reset
System Timer The Intel® QM87 Chipset contains three 8254-style counters with fixed uses.
In addition to the three 8254-style counters, the Intel® QM87 Chipset includes
eight individual high-precision event timers that may be used by the operating
system. They are implemented as a single counter each with its own comparator
and value register.
IPMI
IPMI Controller NXP® ARM7 microcontroller with 512 kB firmware flash and automatic rollback
strategy
The IPMI controller carries out IPMI commands such as monitoring several
onboard temperature conditions, board voltages and the power supply status,
and managing hot swap operations.
The IPMI controller is accessible via two IPMBs, one host Keyboard Controller
Style (KCS) Interface and up to four Gigabit Ethernet Interfaces (IOL).
Table 1: CP6005(X)-SA Main Specifications (Continued)
FEATURES SPECIFICATIONS