Cradlepoint Cellular Modem Charging Cradle PS6PMCW - Manual (Page 6)

User’s Guide for Modem Charging Cradle PS6PMCW 6
Chapter 1 – Preparing the Modem Charging Cradle
Installation Overview
Before using the Modem Charging Cradle, its hardware and software
must be properly configured.
We have provided a step-by-step procedure to help you properly
configure your new Modem Charging Cradle. The procedure is divided
into two major tasks.
•
Preparing the cradle for first use, and
•
Configuring the Network Manager to communicate via the Modem
Charging Cradle.
Preparing the Modem Charging Cradle for First Use
Perform the following steps:
1. Connect the Antenna to the Modem Charging Cradle until it is
finger tight. Slide the rubber sleeve over the antenna so that it
covers the metal connector on the cradle. Now bend the antenna
so that it is pointing upward.
2. Insert your SIM card into the SIM card receptacle.
a. With the tip of a pen or stylus push the ejector pin inward
until the SIM tray is released. Pull the tray out from the
Modem Charging Cradle.
b. Place the SIM card into the tray so that the gold contacts of
the SIM are visible and the notched corner of the card
matches the notched corner of the tray.
c. Reinsert the SIM tray into the Modem Charging Cradle.
3. Connect the Modem Charging Cradle to Line Power using the
supplied power adapters listed on page 5
NOTE
The SIM must have an active data plan.
Configuring the Network Manager for Modem
Communication
Perform the following steps:
1. Configure the Palm Tungsten E2 to work with the Modem
Charging Cradle and a Cingular Data Plan:
•
Open Prefs from the Palm OS Main Menu.
•
Select Communication → Connection.