Kontron KTQM67-mITX - Manual (Page 62)

KTQM67 Users Guide
KTD-N0819-K Page 62
6.14 SPI Recover Jumper (J4)
Recover corrupted Default BIOS procedure:
1. Turn off power.
2. Install "SPI Recover Jumper"(J4).
3. Reboot.
4. Remove "SPI Recover Jumper".
5. Upgrade the BIOS (fx. execute Upd.bat, containing: BF safewrite xxxxxx.xxx).
6. When BIOS upgrade is completed then turn off power completely (inclusive Standby +5V).
7. Wait minimum 10 seconds.
8. Turn on power. System will automatically reboot 4-5 times within 1 minute.
Upgrade Recovery BIOS procedure:
1. Reboot.
2. Install "SPI Recover Jumper"(J4).
3. Upgrade the BIOS (fx. execute UpdRec.bat, containing: BF safewrite xxxxxx.xxx RECOVERY).
4. When BIOS upgrade is completed then turn off power completely (inclusive Standby +5V).
5. Wait minimum 10 seconds.
6. Turn on power. System will automatically reboot 4-5 times within 1 minute.
7. If boot succeed then remove "SPI Recover Jumper".
Upgrade first Default BIOS and then Recovery BIOS with Customised BIOS procedure:
1. Reboot.
2. Upgrade the BIOS (fx. execute Upd.bat).
3. When BIOS upgrade is completed then turn off power completely (inclusive Standby +5V).
4. Wait minimum 10 seconds.
5. Turn on power. System will automatically reboot 4-5 times within 1 minute.
6. Install "SPI Recover Jumper"(J4).
7. Upgrade the BIOS (fx. execute UpdRec.bat).
8. When BIOS upgrade is completed then turn off power completely (inclusive Standby +5V).
9. Wait minimum 10 seconds.
10. Turn on power. System will automatically reboot 4-5 times within 1 minute.
11. Remove "SPI Recover Jumper".
Note: It is not recommended to upgrade both Default BIOS and Recovery BIOS without rebooting and
verification in between, unless you are sure that BIOS and tools works correctly. Otherwise there is a
risk that both BIOS will be corrupted at the same time with the result that board cannot be recovered.
Internal Connectors
The SPI Recover Jumper (J4) is used to select BIOS Recovery Flash
instead of BIOS Default Flash. By default the J4 is not installed.
It is recommended that Jumper is plugged to J4 only in case the
Default BIOS is corrupted, so that board is malfunctioning and do not
boot, or the Recovery BIOS is requested to be upgraded in order to have
sufficient or same support as the default BIOS.
In case Default BIOS seems corrupted then it is recommend to first trying
to use the Load Default BIOS Settings Jumper, see previous page.
When using customised BIOS it is recommended to upgrade both the
Default BIOS and the Recovery BIOS with the Customised BIOS.