Kontron KTT30-mITX - Manual (Page 10)

KTD-N0857-A Page 7 Specifications
KTT30/mITX Users Guide
Onchip Audio Subsystem

Codec interface realize the Inter-IC Sound (I 2 S) specification

The audio codec supports a maximal resolution of 24 bit with 96 kHz sample rate

Three audio jacks for Line-in, Line-out and Microphone-in

S/PDIF input and output as well as a Headphone interface
Onchip SD/MMC Controller

Two ports up to 4 bit data bus width (available on connectors) and one onboard port with 8
bit data width (16 GByte Sandisk NAND flash, bootable)

Supports FIFO and DMA mode access

Supports SDMEM/SDIO specification V3.0 up to 50/25 MHz interface speed

Supports MMC specification V4.4 up to 52 MHz interface speed

Supports CE-ATA ® Digital Protocol specification V1.1 up to 52 MHz interface speed

Supports e.MMC devices
Onchip PCI Express ® Controller

Three ports with maximum data rate of 2.5 GT/s, one port is used for the onboard LAN
controller

All ports only support one lane (PCIe x1)

One miniPCI Express ® connector (mPCIe signals, no mSATA or USB signals)

One miniPCI Express ® connector (mPCIe or mSATA signals, no USB signals - switchable per
software)
Onchip S-ATA ® Controller

Supports S-ATA ® specification V2.0 and AHCI V1.3
Onchip Serial Ports (UARTs)

One RS232C compatible port with CTS and RTS status lines also useable as ccTalk interface

One RS232C compatible port with all status lines
Gigabit LAN (PCI Express ® connection): Intel ® 82574L

Full duplex operation at 10/100/1000 Mbps

Fully compliant with IEEE ® 802.3, IEEE ® 802.3u and IEEE ® 802.3ab
Temperature Monitoring (I 2 C TM connection): ON Semiconductor ® ADT7461A

One onchip thermal sensor and one remote temperature sensor (from SoC)