4 setting time and date, 1 setting time and date using a ntp client, 2 setting time during the boot-up – Kontron AM4530 User Manual
Page 35: 5 setting-up ssh, 6 setting-up dhcp server, Setting time and date, Setting-up ssh, Setting-up dhcp server
22
www.kontron.com
4.4.4
Setting Time and Date
4.4.4.1
Setting Time and Date using a NTP client
Run the following command to set time and date:
# ntpdate <server ip>
(<server ip> is an IP address of a NTP server)
4.4.4.2
Setting Time during the Boot-UP
1 Specify the correct NTP server IP addresses in the /etc/ntp.conf file.
2 Start the NTP daemon manually:
# /etc/init.d/ntpd start
Or automatically set time and date during the boot-up by creating a link to the NTP start script:
ln -sf /etc/init.d/ntpd /etc/rcS.d/S50ntpstart
4.4.5
Setting-up SSH
To setup a SSH, modify the configuration file('/etc/ssh/sshd_config') if required, then start (or restart) the
SSH daemon :
# /etc/init.d/ssh-daemon start
4.4.6
Setting-up DHCP Server
To setup a DHCP server, specify the correct server IP addresses in the /etc/udhcpd.conf file then start the
DHCP server :
# /etc/init.d/dhcp-server start
Or use the following command to make sure this is done automatically during boot-up.
ln -sf /etc/init.d/dhcp-server /etc/rcS.d/S50dhcp-server