Kontron AM5020 IPMI Firmware - Manual (Page 39)

AM5020 IPMI Firmware
ID 1045-0205, Rev. 1.0 Page 31
P R E L I M I N A R Y
5.4.3 Firmware Upgrade - “ipmitool fwum”
“ipmitool” version 1.8.9 doesn’t support HPM.1 correctly. Tool versions prior to this do not
support HPM.1 at all.
The firmware upgrade procedure starts with downloading the binary firmware file using, for
example, the following command:
The next step is the activation of the newly downloaded MMC firmware. This is done using
Detailed information about the currently active firmware versions and the redundant copies
can be obtained using the following command:
Some information about the MMC’s upgrade capabilities can be determined using the com-
mand:
6. FRU Information
The MMC provides 4 kB of non-volatile storage space for FRU information. Some of the data
stored there, such as the Module Current Requirements record or E-Keying information (refer
to AMC.0 specification for details), are mandatory for module functionality in an ATCA/AMC en-
vironment.
Please note that missing FRU information possibly will prevent the AMC module from being ac-
cepted by the carrier controller during the hot swap process, and the module will possibly not
receive payload power.
Full low-level access to read or write a module's FRU information is provided by regular IPMI
FRU Device commands. Please be careful when writing FRU information directly using stan-
dard IPMI commands. Damaging the FRU information may lead to a non-working payload.
6.1 FRU Version Identification
The FRU data fields, as defined in the IPMI specification 2.0, are used to record the version of
the FRU installed. The revision number is incremented for each new release of FRU data.
Example of board FRU ID: “STD_R01”
Example of product FRU ID: “STD_R01”
ipmitool fwum download <Binary_FWFile>.bin
ipmitool fwum upgrade
ipmitool fwum status
ipmitool fwum info