Lifesmart LS-12PAC - Manual (Page 6)

CONTROL PANEL
4
CONTROL PANEL 2
1 REMOTE CONTROLLER SIGNAL RECEIVER
TEMP button
Press this button to adjust setting the temperature within the range of 63F/17C to 88F/31C.
When in the TIMER mode (press and release the TIMER button to enter this status) use
TEMP + or - buttons to set the TIMER time range between 1-12 hours.
2 DIGITAL DISPLAYER
FAN Mode: Indicates room temperature.
COOL or DRY Mode: Indicates setting the temperature.
TIMER Operation: When pressing the TIMER button, this indicates timer time.
If the time has not been adjusted, after 5 seconds the temperature will appear.
ROOM TEMP SENSOR Failure: Display indicates temperature at 77F/25C.
7 POWER button
To turn the air conditioner ON, press the button and the power indicator will light.
To turn the air conditioner OFF,press the button again.
Press this button to set the air speed you desire: High/Low/Med.
UNIT INDICATION button
Allows you to choose between the operation modes: COOL, DRY, FAN, HEAT (heat for the
cooling and heating model).
5
8 MODE button
When selected the corresponding operation mode or fan speed, or the water full, the light will be
on.
6 FAN SPEED button
TIMER button
The TIMER has two modes Switch-ON and Switch-OFF. If the unit is running, pressing the
timer button will enter you into the Switch-OFF mode. If the unit is off, pressing the timer
button will enter you into Switch-ON mode. Pressing this button again will cancel the timer
option. To set the TIMER time use the + or - buttons accordingly. The time can be set
between 1-12 hours.
4
Note:Features and appearance may vary depending on your air conditioner model.
3