Lifesmart LS-12PAC - Manual (Page 8)

REMOTE CONTROL
6
* Point the remote controller at the air conditioner and press the button on the controller. The
instruction signal will be transmitted to the air conditioner.
*
Upon receiving the signal from the remote controller, the air conditioner will make a beep
sound in acknowledgment.
METHOD OF TRANSMISSION
* Do not place the remote in high temperatures, or directly exposed to sunlight.
* Do not drop the remote.
* Do not have any objects obstructing the remote sensor from communicating with the
air conditioner.
*
Do not place heavy objects on the remote.
* Do not drop in water or other liquids.
* If the remote is not functioning, replace the batteries.
REPLACEMENT OF BATTERIES
If the signal is transmitted from the remote to the air conditioner,
and there is no acknowledgement, please replace the batteries.
1. Remove the batteries by sliding the case cover open as the arrow indicates
on the back.
2. Replace with new batteries and pay attention to the "+" and "-" marks of pole indications.
3. Close the back cover.
NOTE:The timer is set on the basis of the present time.So set the present time correctly.
PRESENT TIME SETTING PROCEDURE
Press the HOUR button. (Set to AM 10:)
2
Continually press the HOUR button about 2
seconds.
The time indicator is flickering and can set the HOUR time.
1
When cells are inserted,under the timer operation has not been set,do it as following procedure,
EX:set to AM:10:30.
Press the MIN button. (Set to 30)
3
Press the ON/OFF button to confirm the set time
or it would automatically exit the time setting
state after 15 seconds.
4
CAUTION