Losi LOSA0887 Manual - Manual (Page 20)

82
88 87
86
85
83
BAG C (Continued)
1 7
Figure 41
Figure 42
Step 38. Insert the brake shaft (77) through the 3/16" x 3/8" bearing
(80) in the left gearbox half (83), aligning the teeth of the compound
gear (79) with the diff gear (64) and top gear (75) as you do.
Step 39. Apply a thin coat of white assembly grease (71) along the
inside edge of the left gearbox half (83). This will help seal the gearbox
once it is assembled.
Step 40. Carefully place the right gearbox half (82) over the assembled
left gearbox half (83). Be sure to align each shaft into the bearings in
the right gearbox half (82).
Step 41. Thread the 2-56 x 5/8" cap-head screw (85) into the lower,
rearward hole in the gearbox housing from the right side.
Tip: Be sure you have completed Step 32, and have pre-tapped the
top three holes in the left gearbox before installing the 4-40 x 1-1/
8" buttonhead screws in Step 42.
Step 42. Position the aluminum gearbox brace (88) on the right gear-
box half (82) as shown in Figure 42. Thread two 4-40 x 1" button-head
screws (87) through the gearbox brace (88) and into the two holes in
the gearbox housing.
Step 43. Thread the 4-40 x 3/4" cap-head screw (86) into the upper,
middle hole in the gearbox housing from the right side.
Figure 41
Figure 42
85 86 87
83
77
79
80