Losi LOSA0887 Manual - Manual (Page 9)

BAG A (Continued)
Figure 14
Step 26. Place the chassis brace (29) on top of the chassis (19). Pay particular attention to the servo posts (24). The pins in the top of the servo
posts (24) should fit into the two holes in the chassis brace (29). Once the chassis brace (29) is lined up and in place, secure it to the chassis (19)
with six 4-40 x 3/8" flat-head screws (20) as shown.
*NOTE: Make sure that the pins on the top and bottom of the servo posts stay located in the holes in the servo post bushings and chassis
brace, and that the servo is as close to centered between the two servo posts as possible.
Tip: There is a short thread-cutting screw included in the wrench bag. This screw can be used to tap threads in the holes in the top chassis
brace. Pre-tapping these holes makes it easier to install the screws during assembly.
6
20
29
24
20
Figure 14