Manhattan LCD HD5 - Manual (Page 5)

5
© 2011 Manhattan LCD LLC. - All Rights Reserved
Section: Basic Monitor Adjustments
Powering on the Monitor:
Insert 12V regulated power source via connector into the 12V DC socket. A RED LED will indicate
power is reaching the monitor. If RED LED fails to light, trouble shoot the power adapter or battery.
The screen will be BLACK until you press the POWER button on the monitor or the remote. When the
monitor is powered on the LED status indicator should be green and the monitor will display the
Manhattan LCD logo for 1 second and then switch to a solid blue screen. (May display a black screen
on certain firmware revisions)
Selecting an Input:
Using the Control console located on the left
side of the monitor press the INPUT button.
Use the ^ v buttons located just under the
POWER button and scroll to the appropriate
input. Press the INPUT button to select and
activate the input.
Using the remote control unit with two AAA
batteries installed, point the remote at the Monitor Console’s IR
port (beneath LED indicator) and press the Source Button use the
Up & Down arrows to scroll to the appropriate input and the
enter key to select the input.
Navigating the menu system:
***NOTE*** you must be on an input that is receiving a video
signal to make any changes to any options.
Using the Control console located on the left side of the monitor press the Menu button. To scroll
between Picture, Img.Adj, & Setup tabs use the >< buttons located above the MENU key.
Use the ^ v buttons located just under the POWER button to scroll within a menu tab. To adjust a
specific field use the >< buttons located above the MENU key to apply your changes and go up a level
press the MENU button again to save your changes and go up a level and MENU button once more to
exit the menu.
Using the I/R remote control unit with two AAA batteries installed, point the remote at the Monitor
Console’s IR port (beneath LED indicator) and press the MENU Button use the up & down arrows to
scroll to the appropriate input and the enter key to select the input. To scroll between Picture,
Img.Adj, & Setup tabs use the Left & Right arrow buttons located under the MENU key. Use the Up &
Down arrow buttons located just under the Menu button to scroll within a menu tab. To adjust a
specific field use the Left & Right arrow buttons located below the MENU key to make changes to a
certain field. Press the MENU button again to save your changes and go up a level Use the UP arrow
to get back to the menu tabs and MENU button once more to exit the menu.