Climat ec ontrol, Operating the climate control systems – Mercedes-Benz CLS-Class 2014 Owners Manual User Manual
Page 137
Information about using 3-zone
automatic climate control
Automatic climate control
The 3-zone automatic climate control is only
available on vehicles for Canada.
The following contains instructions and
recommendations to enable you to get the
most out of your automatic climate control.
R
Activate climate control using the à and
¿ buttons. The indicator lamps above
the à and ¿ buttons light up.
R
In automatic mode, you can also use the
ñ button to set a climate mode
(FOCUS/MEDIUM/DIFFUSE). The
MEDIUM level is recommended.
R
Set the temperature to f 72 ‡ (22 †).
R
Only use the "Windshield defrosting"
function briefly until the windshield is clear
again.
R
Only use air-recirculation mode briefly, e.g.
if there are unpleasant outside odors or
when in a tunnel. The windows could
otherwise fog up, since no fresh air is drawn
into the vehicle in air-recirculation mode.
R
Use the ZONE function to adopt the
temperature settings on the driver's side
for the front-passenger side and the rear
compartment as well. The indicator lamp
above the á button goes out.
R
Use the residual heat function if you want
to heat or ventilate the vehicle interior
when the ignition is switched off. The
residual heat function can only be activated
or deactivated with the ignition switched
off.
R
Vehicles with COMAND Multimedia-
System: if you change the settings of the
climate control system, the climate status
display appears for approximately three
seconds at the bottom of the screen in the
COMAND display. See also the separate
COMAND operating instructions. You will
see the current settings of the various
climate control functions.
ECO start/stop function
During automatic engine switch-off, the ECO
start/stop function only operates at a
reduced capacity. If you require the full
climate control output, you can switch off the
ECO start/stop function by pressing the ECO
button (
Y
page 152).
Operating the climate control
systems
Switching climate control on/off
Points to observe before use
When the climate control is switched off, the
air supply and air circulation are also
switched off. The windows could fog up.
Therefore, switch off climate control only
briefly
i
Activate climate control primarily using
the à button (
Y
page 137).
Activating/deactivating
X
Turn the SmartKey to position 2 in the
ignition lock (
Y
page 147).
X
To switch on: press the à button on
the control panel for the climate control.
The indicator lamp in the à button lights
up. Airflow and air distribution are set to
automatic mode.
or
X
Press the ^ button.
The indicator lamp in the ^ button goes
out. The previously selected settings are
restored.
X
To switch off: press the ^ button.
The indicator lamp in the ^ button lights
up.
Operating the climate control systems
135
Climat
ec
ontrol