Driving and parking, Driving systems – Mercedes-Benz CLS-Class 2013 Owners Manual User Manual

Page 204

Advertising
background image

If Active Blind Spot Assist detects a risk of a
lateral collision in the monitoring range, a
course-correcting brake application is carried
out. This is meant to assist you in avoiding a
collision.
If a course-correcting brake application
occurs, red warning lamp : flashes in the
exterior mirror and a dual warning tone
sounds. In addition, the message shown in
the illustration appears in the multifunction
display.
The course-correcting brake application is
available in the speed range between 20 mph
(30 km/h) and120 mph (200km/h).
Either no braking application, or a course-
correcting brake application adapted to the
driving situation occurs if:

R

there are vehicles or obstacles, e.g. crash
barriers, located on both sides of your
vehicle.

R

a vehicle approaches you too closely at the
side.

R

you have adopted a sporty driving style with
high cornering speeds.

R

you clearly brake or accelerate.

R

a driving safety system intervenes, e.g.
ESP

®

or PRE-SAFE

®

Brake.

R

ESP

®

is switched off.

R

a loss of tire pressure or a defective tire is
detected.

Switching on Active Blind Spot Assist

X

Make sure that the radar sensor system
(

Y

page 223) and Active Blind Spot Assist

(

Y

page 219) are activated in the on-board

computer.

X

Turn the SmartKey to position

2 in the

ignition lock.
Warning lamps : light up red in the
exterior mirrors for approximately
1.5 seconds and then turn yellow.

Active Lane Keeping Assist

Important safety notes

G

WARNING

Active Lane Keeping Assist does not keep
your vehicle in its lane. It is only an aid and
may detect the lane markings on the road
incorrectly or not at all.
The system may be impaired or may not
function if:

R

there is poor visibility, e.g. due to
inadequate illumination of the road surface,
snow, rain, fog or spray.

R

there is glare, e.g. from oncoming traffic,
the sun, or reflection from other vehicles.

R

the windshield is dirty, fogged up or
covered, for instance by a sticker, in the
vicinity of the camera.

R

several or no lane markings for a single lane
are present.

R

the lane markings are worn away, dark or
covered up, e.g. by dirt or snow.

R

the distance to the vehicle in front is too
small, and as a result the lane markings
cannot be recognized.

R

the lane markings on the road are unclear,
e.g. near roadworks.

202

Driving systems

Driving and parking

Advertising