Adjusting the multicontour seat, Seats, steering wheel and mirrors, Seats – Mercedes-Benz G-Class 2013 Owners Manual User Manual

Page 90

Advertising
background image

center of the head restraint supports the back
of the head at eye level. This will reduce the
potential for injury to the head and neck in the
event of an accident or similar situation.
With a rear seat occupied, make sure to move
the respective head restraint up from the
lowest non-use position and have the
occupant adjust the head restraint properly.
Do not drive the vehicle without the seat head
restraints installed when the rear seats are
occupied. Head restraints are intended to
help reduce injuries during an accident.

G

WARNING

Make sure the rear seat head restraints
engage when placing them upright manually.
Otherwise their protective function cannot be
ensured.
The back of the head will not be supported in
the event of a collision. That could cause
serious or even fatal injuries. Rear seat
occupants can be seriously injured or killed.

Adjusting the rear seat head restraint

height

X

Once the head restraint is fully lowered,
press release catch :.

X

To raise: pull the head restraint up to the

desired position.

X

To lower: press release catch : and push
the head restraint down until it is in the
desired position.

Installing/removing the rear seat head

restraints

X

To remove: pull the head restraint up to

the stop.

X

Press release catch : and pull the head
restraint out of the guides.

X

To re-install: place the head restraint in

the guides of the backrest.

i

The notches on the guide rod must be on

the left-hand side when viewed in the
direction of travel.

X

Push the head restraint down until you hear
it engage in position.

Adjusting the multicontour seat

:

To adjust the thigh cushion

;

To adjust the backrest contour in the
lumbar region

=

To adjust the backrest contour in the
upper back region

?

To adjust the side bolsters of the seat
backrest

You can adjust the contour of the front seats
individually so as to provide optimum support
for your back and sides.

X

Make sure that the SmartKey is in position
1 or 2 (

Y

page 139) in the ignition lock.

88

Seats

Seats, steering wheel and mirrors

Advertising
This manual is related to the following products: