Rear seat ente rtainment system, Basic functions – Mercedes-Benz C-Coupe 2012 COMAND Manual User Manual

Page 215

Advertising
background image

X

Insert the new batteries. Observe the

polarity markings on the batteries and

battery compartment when doing so.

Left-hand battery: the positive pole (+)

must face upwards.
Right-hand battery: the positive pole (+)

must face downwards.

X

To close the battery compartment:

insert battery compartment cover =

starting with retaining lugs ? into the

battery compartment and allow catch

tab ; to engage in place.

On the cordless headphones

The battery compartment cover is located on

the left headphone.

:

Battery compartment cover

The cordless headphones contain 2 type AAA,

1.5 V batteries.

X

To open the battery compartment: flip

battery compartment cover : upwards.

As you do so, hold the left-hand side of the

headphones as shown to prevent the

batteries from falling out.

X

Remove the discharged batteries from the

tray.

X

Insert the new batteries. Observe the

polarity markings on the batteries and

battery compartment when doing so.

Left-hand battery: the positive pole (+)

must face upwards.

Right-hand battery: the positive pole (+)

must face downwards.

X

To close the battery compartment:

press battery compartment cover

downwards until it engages into place.

If the batteries have been inserted

correctly, the indicator lamp will light up

green when the headphones are switched

on.

Basic functions

Using headphones

You can use the cordless headphones

supplied and/or up to two sets of corded

headphones connected to the corresponding

jack of the rear-compartment screens

(

Y

page 209).

Information on:

R

switching the cordless headphones on/off

R

adjusting the volume of the headphones

R

selecting a screen for the headphones

can be found in the Cordless headphones

section (

Y

page 211).

Using the main loudspeakers

This function is available in conjunction with

COMAND.
You can use the vehicle loudspeakers to

listen to a disc inserted in the rear-

compartment drive. To do so, at least one of

the rear-compartment screens must be set to

disc mode.

X

To set using COMAND: press, for

example, the $ function button to

switch on an audio mode.

X

Select

Audio

by sliding ZV the COMAND

controller and press W to confirm.

The Audio menu appears.

X

Select

Rear Audio

by turning cVd the

COMAND controller and press W to

confirm.

Basic functions

213

Rear

Seat

Ente

rtainment

System

Z

Advertising