Mercedes-Benz G-Class 2011 Owners Manual - Manual (Page 210)

X Press the W or X button to activate
or deactivate the
Headlamp Delayed
Shut-off function.
X Before switching off the engine, turn the
light switch to position Ã.
The exterior lighting delayed shut-off is
activated.
X Press the &, V or U button to
select a different display.
To deactivate the delayed shut-off
temporarily:
X Before leaving the vehicle, turn the
SmartKey to position
0 in the ignition lock.
X Turn the SmartKey to position 2 in the
ignition lock and back to position 0.
The delayed shut-off is deactivated.
The delayed shut-off is reactivated the next
time you start the engine.
Activating/deactivating the interior
lighting delayed switch-off
When you activate the
Interior Lighting
Delayed Shut-off function and remove the
SmartKey from the ignition lock, the interior
lighting remains on for 10 seconds.
X Press V or U on the steering wheel
to select the
Settings menu.
X Press & to call up the selection of
submenus.
X Press the W or X button to select the
Lighting submenu.
X Press the & button to select Interior
Lighting Delayed Shut-off.
X Press the W or X button to activate
or deactivate the
Interior Lighting
Delayed Shut-off function.
X Press the &, V or U button to
select a different display.
Vehicle
Activating/deactivating the automatic
locking feature
When you activate the
Automatic Door
Locking function, your vehicle will be
centrally locked above a speed of
approximately 9 mph (15 km/h).
i Further information on the automatic
locking feature ( Y page 81).
X Press V or U on the steering wheel
to select the
Settings menu.
X Press & to call up the selection of
submenus.
X Press the W or X button to select the
Vehicle submenu.
X Press & to select Automatic Door
Locking.
X Press W or X to switch Automatic
Door Locking on or off.
X Press the &, V or U button to
select a different display.
Activating/deactivating the radar sensor
system
If the radar sensor system is switched off,
Blind Spot Assist (
Y page 191) is deactivated.
i USA only: This device has been approved
by the FCC as a “Vehicular Radar System”.
The radar sensor is intended for use in an
automotive radar system only. Removal,
tampering, or altering of the device will void
any warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
i Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause interference,
and
208
Menus and submenus
On-board computer and displays
BA 251 USA, CA Edition A 2011; 1; 3, en-US
d2sboike
Version: 3.0.3.5
2010-04-16T14:31:55+02:00 - Seite 208