Mercedes-Benz SLK-Class 2010 Owners Manual - Manual (Page 112)

Resetting fuel consumption statistics
X Press button U or V repeatedly until
the message
From Start appears in the
multifunction display.
X Press button & or * repeatedly until
the reading that you want to reset appears
in the multifunction display.
X Press and hold the reset button . in the
instrument cluster until the respective
values are reset to
0.
The fuel consumption statistics reset
automatically to 0 after 99
999 miles or
9 999 hours, whichever occurs first.
Distance to empty
X Press button U or V repeatedly until
the message
From Start appears in the
multifunction display.
X Press button & or * repeatedly until
the message
Range: appears in the
multifunction display.
The calculated remaining driving range
based on the current fuel tank level
appears in the multifunction display.
If only very little fuel is left in the tank, a
vehicle at the fuel pump C appears
instead of the remaining driving range.
Telephone menu
G
Warning!
A driver’s attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking a
telephone call. If you choose to use the
telephone while driving, please use the hands-
free device and only use the telephone when
weather, road and traffic conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.
You can connect your telephone to the audio
system (
Y page 146) or to the COMAND
system via Bluetooth ® , see separate
COMAND system operating instructions.
X Switch on the audio system ( Y page 117)
or the COMAND system, see separate
COMAND system operating instructions.
X Press button U or V repeatedly until
the
Telephone menu appears in the
multifunction display.
One of the following messages will appear
in the multifunction display:
R
No Service: No network is available.
R
Bluetooth Ready: The telephone has
not been connected to the audio system
or COMAND system via Bluetooth
® yet.
X Connect the telephone to the audio
system or COMAND system via
Bluetooth
® .
R
Ready or name of the network provider
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the
multifunction display you will then see the
following message, or if available, the caller
ID (number or name):
110
Control system
Controls in detail
171_AKB; 3; 60, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-11T16:00:23+02:00 - Seite 110