Mercedes-Benz S-Class 2010 - Manual (Page 242)

Multifunction display
For example, telephone numbers are shown
in the multifunction display : while dialing
when the main
Telephone menu is selected
in the instrument cluster control system.
Symbols
The following symbols are found in the Voice
Control System pages:
\
This symbol stands for commands and
voice names you are speaking.
^ This symbol stands for voice output by
the Voice Control System.
_ This symbol indicates that information
is available on the COMAND display.
Voice Control System navigation
Important notes
Safety notes for using the Voice Control
System
G Observe Safety notes, see page 237.
Safety notes for using the navigation
system
G
Observe Safety notes, see page 95.
Navigation operation
You can use the Voice Control System to
R enter a country, state or province
R enter a city
R enter a district or a center
R enter a street
R enter an intersection
R enter a house number
R enter a zip code
R find address
R enter a POI (point of interest)
R select one of your last destinations
R calling up route information
R
save a destination
R
navigate to a destination stored in the
destination memory of the address book
R
display the map
R
zoom the map in or out
R
listen to the destination memory
R
cancel route guidance
R
start route guidance
R
turn guide instructions on or off
Selecting navigation mode
X Press button ?.
X Speak the command “Navigation”.
X Press button ?.
X Speak one of the navigation commands.
i You can use spoken navigation
commands even when COMAND is in a
mode other than navigation mode.
Navigation commands
i You cannot start the route guidance until
all necessary address data has been
entered.
240
Voice Control System navigation
Control systems
221_AKB; 6; 20, en-US
d2ugruen,
Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 240