Mercedes-Benz C-Class 2010 Owners Manual - Manual (Page 136)

X Press button a.
X Press button : or 9 to select the
Daytime Running Lamps: function.
The current setting
Enabled or Disabled
is shown.
X Press button a to change the current
status.
Depending on the previous status, the
Daytime Running Lamps: mode will be
Enabled or Disabled.
With Daytime Running Lamps mode
enabled and the exterior lamp switch at
position $ or c, the low-beam
headlamps are switched on when the engine
is running.
In low ambient light conditions the following
lamps will come on additionally:
R
Parking lamps
R
Tail lamps
R License plate lamps
R Side marker lamps
For more information on the daytime running
lamp mode, see (
Y page 91).
i Make sure the exterior lamp switch is set
to M or c when you switch off the
daytime running lamps while driving at
night.
For safety reasons, resetting all the functions
of all submenus to the factory settings while
driving (
Y page 130) will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Cannot Be Completely Reset to
Factory Settings while Driving..
Switching locator lighting on or off
With the
Locator Lighting: function
activated and the exterior lamp switch in
position c
R
the exterior lamps will come on during
darkness when the vehicle is unlocked with
the SmartKey.
The lamps will go out when the driver’s door
is opened.
If you do not open the driver’s door after
unlocking the vehicle with the SmartKey,
the lamps will go out automatically after
approximately 40 seconds.
R
the exterior lamps will remain on for
15 seconds during darkness after exiting
the vehicle and closing all doors.
If, after turning off the engine, you do not
open or close a door, the lamps will
automatically go out after 60 seconds.
The following lamps will come on
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
R
Front fog lamps
X Press button = or ; to select the
Settings menu.
X Press button : or 9 to select the
Lights submenu.
X Press button a.
X Press button : or 9 to select the
Locator Lighting: function.
The current setting
Enabled or Disabled
is shown.
134
Control system
Controls in detail
204_AKB; 5; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T17:54:06+02:00 - Seite 134