Windshield:washer system – Mercedes-Benz SL-Class 2008 Owners Manual User Manual

Page 290

Advertising
background image

289

Operation

Engine compartment

The coolant level is correct if the level

ț

for cold coolant:
is up to the upper mark on the
bracing rib of the coolant expansion
tank (translucent)

ț

for warm coolant:
is approximately 0.6 in (1.5 cm) higher

̈

Add coolant as required.

̈

Replace and tighten cap.

For more information, see “Coolants”
(

page 463).

Windshield washer system and
headlamp cleaning system

The windshield washer reservoir is located
in the engine compartment.

1 Cap for windshield washer reservoir

Fluid for the windshield washer system
and the headlamp cleaning system is
supplied from the windshield washer
reservoir. It has a capacity of approxi-
mately 7.4 US qt. (7 l).

During all seasons, add MB Windshield
Washer Concentrate “MB SummerFit” to
water. Premix the windshield washer fluid
in a suitable container.

̈

Use the tab to pull cap

1 upwards.

̈

Refill the reservoir with MB Windshield
Washer Concentrate “MB SummerFit”
and water (or commercially available
premixed windshield washer sol-
vent/antifreeze, depending on ambient
temperatures).

For more information, see “Windshield
washer system and headlamp cleaning
system” (

page 465).

!

SL 600 and SL 65 AMG: Only open the cap

on coolant expansion tank

1. Never open the

cap between the two charge-air coolers. Other-
wise, the engine could be damaged.

Warning!

G

Washer solvent/antifreeze is highly flamma-

ble. Do not spill washer solvent/antifreeze

on hot engine parts, because it may ignite

and burn. You could be seriously burned.

!

Always use washer solvent/antifreeze

where temperatures may fall below freezing
point. Failure to do so could result in damage to
the washer system/reservoir.

!

Only use washer fluid which is suitable for

plastic lenses. Improper washer fluid can dam-
age the plastic lenses of the headlamps.

Advertising