Crosley W10223589B - Manual (Page 7)

7
Dryer Results
Clothes are not drying satisfactorily, drying times are too
long, or load is too hot
Is the lint screen clogged with lint?
Lint screen should be cleaned before each load.
Is the exhaust vent or outside exhaust hood clogged with
lint, restricting air movement?
Run the dryer for 5-10 minutes. Hold your hand under the
outside exhaust hood to check air movement. If you do not
Installation Instructions.
Are fabric softener sheets blocking the grille?
Use only one fabric softener sheet, and use it only once.
Is the exhaust vent the correct length?
Check that the exhaust vent is not too long or has too many
turns. Long venting will increase drying times. See the
Installation Instructions.
Is the exhaust vent diameter the correct size?
Use 4" (102 mm) diameter vent material.
Is the dryer located in a room with temperature below
45ºF (7ºC)?
Proper operation of dryer cycles requires temperatures above
45ºF (7ºC).
Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and
bottom of the door. The rear of the dryer requires a minimum
of 5½" (140 mm) airspace. See the Installation Instructions.
Has an air dry cycle been selected?
Select the right cycle for the types of garments being dried.
Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Cycle time too short
Is the automatic cycle ending early?
Change the dryness level setting on automatic cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.
Lint on load
Is the lint screen clogged?
Lint screen should be cleaned before each load.
Stains on load or drum
Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue
jeans). This will not transfer to other clothing.
Loads are wrinkled
Was the load removed from dryer at the end of the cycle?
Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Odors
Have you recently been painting, staining or varnishing in
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
WARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death
WARNING
Explosion Hazard
gasoline, away from dryer.
for a garage installation.
feel air movement, clean exhaust system of lint or replace
Timer does not noticeably advance
Is the dryer set to Timed or Air Dry?
The timer moves slowly and continuously for the time setting.
Is the dryer set to Auto-Sense Dry or Auto Sense Dry Plus?
The timer moves only when the clothing is mostly dry. See
“How Auto-Sense Dry Works” or “How Auto-Sense Dry Plus
Works” (depending on your model) in “Dryer Use.”
Failure to do so can rersult in death, explosion, or fire.
Keep flammable materials and vapors, such as
Place dryer at least 18 inches (460 mm) above the floor
will be gone after the first cycle.
Is the electric dryer being used for the first time?
exhaust with heavy metal or flexible metal vent. See the
or fire.