Origin Live Solicore S Instructions & Cable End Joining - Manual (Page 2)

BI-WIRING
If you wish to bi-wire your speakers then don’t twist the thick wires together at the speaker end but
use the red wire and black wire for the bass / midrange unit and the yellow and blue wire for the
tweeter unit (as shown below).
+VE -VE
+VE -VE
TREBLE
BASS
YELLOW BLUE
BLACK
RED
SOLI-CORE SUPER SET UP INSTRUCTIONS
Read Carefully
Speaker Cable
To be on the safe side, turn off your equipment when connecting or disconnecting the cables. It is
important to note that the cable is “directional” and should be set up exactly as shown in the diagram
below. Each wire end may be bent to form a loop to go over its binding post (thus ensuring good
electrical contact). Banana plugs should be avoided if possible as they degrade the signal and it they
are used they should only be of high quality
Good connections are vital so ensure that electrical contacts are as tight as possible and clear audio
cables away from mains cable (i.e. plug sockets and leads for equipment). Avoid coiling wires from
different channels together.
CABLE DESIGN
RED / YELLOW
BLACK / BLUE
BLACK BLACK
RED RED
Indented letters on cable run from speaker to amplifier
S,
P
E
A
K
E
R
A
M
P
L
I
F
I
E
R
The system will produce a superb sound with the introduction of Soli-core. In observing the changes,
the following points are worth mentioning:-
(1) The better your system and the longer your original cable, the greater the difference.
(2) Loud volume levels will reveal more. When making comparisons bear In mind that Soli-core
should be played at slightly louder volumes than stranded cables because the music becomes so
uncluttered that it sounds quieter.
(3) Compare bass weight, voice clarity and presence, plus top end presence in particular. Separation
and imaging will also be excellent.