Pizzacraft PM6011 Pizza Oven Leg Kit - Manual (Page 6)

6
8. Align tank ring so that the thumb screw hole is facing towards the back of the oven. Secure the tank ring to
the tank ring frames using M6x8 nuts(4), so that the nuts are on the outside and the carriage bolts (4) are on
the inside of the tank ring. DO NOT FULLY TIGHTEN THESE BOLTS UNTIL THE FINAL STEP OF
ASSEMBLY.
Tank ring should be
oriented so thumb screw
hole faces out the back
Notice how tank ring frames are
oriented. “L” bracket should be facing
out the left and right sides.
7. Insert the straight ends of the tank ring frames(4) one at a time into the slots near the base of the lower leg so
that they rest inside the lower frames within the slots. Each slot should contain one end of the bottom frame
as well as one tank ring frame . Secure tank ring frames and bottom frames with M4x25 screws(4). (Note:
the “L” bracket of the tank ring frames should be facing each other on the left and right sides)