Pl astec ventilation, inc, Disassembly instructions, Installation, operation & maintenance manual – Plastec Adjustable Dampers User Manual
Page 10: Plastec pss series stainless steel utility blowers
PL ASTEC VENTILATION, INC.
Installation, Operation & Maintenance Manual
DISASSEMBLY INSTRUCTIONS
PLASTEC PSS SERIES STAINLESS STEEL UTILITY BLOWERS
Before beginning these instructions, place this fan on a bench or table top that can
support its weight. For tool size see illustration.
1) Remove Hex cap screws from the motor plate. (Be careful not to damage the impeller
during this operation.)
2) Lift the assembly clear of the fan housing. Set the fan housing aside.
3) Remove the hub cap and teflon gasket.
4) Loosen the shaft locking screws (hub).
5) Use a gear puller to remove the impeller from the shaft. Always use the bushing as the
pulling point. Pulling on the blades or rim of the impeller will cause irreparable damage.
6) Remove the 4 motor plate bolts to remove the motor plate from the motor.
7) Remove the motor support stand if required by this operation.
(See Illustrations)
– 9 –
NOTE: Any new assembly parts or mounting hardware sourced
must be 316 Stainless Steel
July 2012