Reliance Controls THP221 - Manual (Page 2)

Setting up the THP221 Alarm
INSTALLING THE BATTERY and AC ADAPTER OPTION
Slide the battery compartment cover down and install an alkaline 9 volt battery.
Be careful not to press the red PANIC button on the keypad once the battery is installed, or the alarm will sound for 30
seconds until the correct password is entered (default is “000”).
You can also use AC adapter rather than a 9 volt battery.
It would have to meet these specifications:
Output DC 9 volt, 500mA, 3.5mm male plug, center positive
MOUNTING THE UNIT
To mount the unit on the wall, you can use the anchors and screws (included). Mount the wired magnetic sensor to the
door frame or window frame using double-side adhesive (included) or small screws (included). Mount the other magnetic
sensor piece adjacent to the wired sensor on the door or window itself using the same method. Ensure the arrows line up,
and that the two magnetic sensors are no more than ¼ inch apart.
SETTING UP A PASSWORD
• The default password is pre-set to “000”.
• You can program your own password and change it at any time.
• The password can be 1 to 6 digits.
• If you enter the wrong password, or too many digits, a short error “buzz tone” will sound.
• To reset the password if forgotten, remove the battery for 3 minutes and it will reset to “000”
1. Enter the default password “000” and press the * button (PROGRAM button).
2. Enter your new personal password (1-6 digits) and press the * button again.
3. You will then hear 2 quick beeps, indicating the new password was saved.
CHANGING YOUR PASSWORD
1. Enter the current password and press the * button (PROGRAM button).
2. Enter your new personal password (1-6 digits) and press the * button again.
3. You will then hear 2 quick beeps, indicating the new password was saved.
RESETTING YOUR PASSWORD
1. If you forgot the password, it can be reset.
2. Remove the battery for 3 minutes, and it will reset the password to the default of “000”.
3. Follow the steps “SETTING UP A PASSWORD”.