Rice Lake 920i USB Programmable Indicator Controller - 6V DC-to-DC Power Supply - Manual (Page 2)

Location of power supply inside 920i
enclosure
2 AddendumTitle
Figure 2. Location of Power Supply
2. Strip back the outer jacket on both ends of the power cord by 3".
3. Strip the wire insulation on DC power supply 1/4" on all ends, Figure 3.
Figure 3. Tinned Wire Ends
4. Tin the end of the wires to prevent fraying as shown in Figure 3.
5. Install cable and cord grip by running it through the enclosure, Figure 4.
Figure 4. Install Power Cord into Enclosure