Rice Lake CW-90/90X - 720i - 820i - iQUBE2 - LaserLT WLAN - Manual (Page 2)

WLANACT LED
ON when not connected; OFF when connected
CFG/LOOP Jumpers
Xcvr/WiPt Switch
J2 RS-232 Configuration
Connection
Reset Jumper
(See note below)
2 WLAN Installation Instructions
Figure 2 WLAN Option Card
Note
This jumper is used to reboot the option board by momentarily shorting it out.
It is not used to reset the option board’s configuration.